It happens when you do nothing more than quickly shut off a faucet. BANG! It sounds like a shock wave just went through your pipes! You may even see faucets and other plumbing fixtures vibrate when this happens—that’s how forceful the impact is. This phenomenon is called water hammer for good reason (technically, it is known as hydraulic shock). The water sends a shock wave that can exert pressures at hundreds of pounds per inch. Water hammer is annoying but also can damage your plumbing system. Your water supply pipes may already include old-school solutions for water hammer (and you recharge this system, if necessary), but chances are the best fix is installing water hammer arrestors.
What Causes Water Hammer
Water hammer (hydraulic shock) is by far the loudest and most common plumbing noise problem in the home. It occurs when a faucet or appliance quickly shuts off the flow of water into the fixture or appliance, causing a shock wave that makes the water supply pipes bang against each other or against wood framing members (wall studs, floor joists, etc.). Water hammer can be caused by any fixture or appliance that uses water, but some of the most common culprits are clothes washers and dishwashers. These typically have solenoid valves that shut off the flow of water very quickly, so the water flow goes from fully on to fully off in a split second.
The Traditional Solution
Water supply systems in older homes may have pipe fittings called air chambers located on each hot and cold water line at or near each faucet or water inlet valve. This is rarely visible, except in unfinished spaces such as a utility room. Otherwise, they are hidden behind walls along with the other plumbing pipes. The purpose of the air chamber is to act as a shock absorber for water when it is flowing at high speed under pressure. Since air compresses (it’s a vapor) and water doesn’t, the air chamber provides the water a place to temporarily expand into and thus softens the blow of the water shock wave when the faucet is turned off quickly.
Air chambers are often fabricated on-site by the plumber and installed at the faucet’s water supply. They typically consist of a vertical length of capped pipe about 12 inches long or longer and are the same diameter as the water supply pipe. The problem with these makeshift air chambers is that they can fill up with water over time, eliminating the air that serves as a shock absorber.
You can recharge water-filled chambers by shutting off the water supply and draining the pipes, which allows air to fill the chambers, and it gets trapped there when the water is turned back on. If this solution isn’t effective, try installing water hammer arrestors.
Water Hammer Arrestors
Usually, the best long-term solution for eliminating water hammer is to install a water hammer arrestor on each water supply line that makes noise. A water hammer arrestor works much like an old-style air chamber but includes an air- or gas-filled chamber that is sealed by a diaphragm or piston. The diaphragm or piston moves to absorb the shock of the water, while keeping the water and the shock-absorbing air or gas separated.
Water hammer arrestors come in many types. Some are installed with soldered pipe connections, while others have threaded fittings that twist on just like a garden hose. The latter is an easy solution for water hammer caused by clothes washers. You simply remove the appliance’s water hoses from their faucet or valve connections in the laundry room, install the arresters onto the faucets, then connect the hoses to the arrestors. There are also arrestors that use push-in fittings for installation onto copper (and other rigid pipes) without soldering.